AEG S73130KDX3 Notice D'utilisation page 32

32 www.aeg.com
Problem
The compressor does not
start immediately after
pressing the COOLMATIC,
or after changing the tem-
perature.
Water flows inside the refrig-
erator.
Water flows on the floor.
Temperature cannot be set.
DEMO appears on the dis-
play.
Door is misaligned or inter-
feres with ventilation grill.
The temperature in the ap-
pliance is too low/too high.
All manuals and user guides at all-guides.com
Possible cause
This is normal, no error has
occurred.
The water outlet is clog-
ged.
Food products prevent
that water flows into the
water collector.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
The COOLMATIC function
is switched on.
The appliance is in demon-
stration mode.
The appliance is not level-
led.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
Food products placed in
the appliance were too
warm.
Many food products were
put in at the same time.
The door has been
opened often.
The COOLMATIC function
is switched on.
There is no cold air circula-
tion in the appliance.
Solution
The compressor starts after a
period of time.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Attach the melting water out-
let to the evaporative tray.
Switch off COOLMATIC man-
ually, or wait until the function
resets automatically to set the
temperature. Refer to "
COOLMATIC function".
Keep the Mode pressed for
approximately 10 seconds un-
til a long sound is heard and
display shuts off for a short
time.
Refer to "Levelling".
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Allow food products to cool to
room temperature before stor-
ing.
Wait some hours and then
check the temperature again.
Open the door only if necessa-
ry.
Refer to "COOLMATIC func-
tion".
Make sure that there is cold air
circulation in the appliance.