AEG S73130KDX3 Notice D'utilisation page 31

All manuals and user guides at all-guides.com
Problem
The appliance is noisy.
Audible or visual alarm is on. The cabinet has been re-
A rectangular symbol is
shown instead of numbers
on the Temperature Display.
The lamp does not work.
The lamp does not work.
The compressor operates
continually.
There is too much frost and
ice.
Possible cause
There is no voltage in the
mains socket.
The appliance is not sup-
ported properly.
cently switched on or the
temperature is still too
high.
The temperature in the ap-
pliance is too high.
The door is left open.
The temperature in the ap-
pliance is too high.
Temperature sensor prob-
lem.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor-
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor-
rectly.
The COOLMATIC function
is switched on.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
ENGLISH
Solution
Connect a different electrical
appliance to the mains socket.
Contact a qualified electrician.
Check if the appliance stands
stable.
Refer to "Door Open Alarm"or
"High Temperature Alarm".
Refer to "Door Open Alarm"or
"High Temperature Alarm".
Close the door.
Contact a qualified electrician
or contact the nearest Author-
ized Service Centre.
Contact the nearest Author-
ized Service Centre (the cool-
ing system will continue to
keep food products cold, but
temperature adjustment will
not be possible).
Close and open the door.
Contact the nearest Author-
ized Service Centre.
Refer to "Operation" chapter.
Wait some hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "Closing the door".
Refer to "COOLMATIC func-
tion".
Refer to "Closing the door".
31