Table des Matières
Publicité
Malfunction
Cause
Plungers cannot
Cartridge not inserted
be moved into the
correctly
cartridge
Plunger disc defective
The unit does not
The "Start" button is
switch off when
jammed
the "Start" button is
released
Hand wheels are
Foil of a bag is wedged
difficult to turn back
between the cartridge
and the plunger
Hand wheels
Pressure on foil bags
completely blocked
has not been released
Operating LED does
No power to the unit
not light up
Main switch has not
been turned on
7. Maintenance and Care
7.1 Replacement of the Plunger Discs
If damaged, the plunger discs must be replaced. Only original parts may be
used as replacements to insure safe operation.
Turn off the unit and disconnect the plug from the power source. Use an
Allen wrench to remove the screw in the center of the plunger disc.
Remove the disc and screw a new one into place (Fig. 26).
When changing the plunger discs, make sure you position them
with the correct alignment (see Fig. 26) to prevent damage to the foil
bags.
7.2 Care
Clean all components with a soft cloth and, if necessary, a mild cleaning agent
(e. g. dish-washing detergent). Solvents or abrasive cleaners may not be used
in any case, as they can damage the plastic components!
- Cleaning agents must not enter the unit!
To disinfect all components, spray the disinfectant on a towel and use it to
disinfect the unit. Do not spray the disinfectant directly on the device.
- Disinfectant agents must not enter the unit!
- Dry residual disinfectants on the device with a soft and fluff-free cloth,
as they damage the plastic components.
If necessary, ask the manufacturer of the disinfectant if its constant use will
damage plastic surfaces.
7.3 Maintenance and Repair
No components inside the unit require servicing or repair by the user.
3M Deutschland GmbH will accept responsibility for the safety, reliability, and
correct function of the unit only if:
- Any modifications or repairs are carried out only by personnel
authorized to do so by 3M Deutschland GmbH;
- The electrical fittings in the room comply with all regulatory
requirements;
- The unit is operated according to these Operating Instructions.
Plastic cartridges are subject to wear depending on the material and
frequency of use and are therefore not covered by the warranty for this unit.
They should be regularly checked for signs of wear (e.g., fissures) and
replaced with new, metal-reinforced Penta cartridges two years after initial
operation at the very latest. The use of worn or defective cartridges can have
adverse effects on the evenness of the mixture, reducing the quality of the
impression.
8
8. Return of Old Electric and Electronic
Remedy
Check the correct
positioning of the
cartridge in the
8.1 Collection
Pentamix 3 unit
Check plunger discs
Users of electric and electronic equipment are required to collect their old
for damage and replace
equipment separately from other waste in accordance with the regulations
if necessary (see 7.1)
of the specific country. Old electric and electronic equipment must not be
disposed of with unsorted household waste. This separate collection is a
Pull the "Start" button
prerequisite for recycling and reprocessing as an important method for
up or, if necessary, use
preserving environmental resources.
the main switch to turn
off the unit and free the
"Start" button
8.2 Return and Collection Systems
Run the plunger to the
When your Pentamix 3 is no longer usable, do not dispose of the device with
top position against
household waste. 3M Deutschland GmbH has set up special disposal facilities
the resistance. Check
to handle the equipment. Details about the procedure for the specific country
the plunger discs and
can be obtained from the pertinent 3M Deutschland GmbH subsidiary.
replace if necessary
(see 7.1)
8.3 Meaning of the Symbols
Press the "Start" button
The EU Directive prohibits the disposal of any electric or electronic devices
briefly (1 sec.)
marked with these symbols in combination with household waste.
Check the connection
of the power plug at the
unit and the outlet
Turn on main switch
9. Customer Information
No person is authorized to provide any information that deviates from the
information provided in this instruction sheet.
8.1 Warranty
3M Deutschland GmbH warrants this product to be free from defects in
material and manufacture. 3M Deutschland GmbH MAKES NO OTHER
WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY
OR FITNESS FOR A PARTICULAR PURPOSE. User is responsible for
determining the suitability of the product for user's application. If this
product is defective within the warranty period, your exclusive remedy and
3M Deutschland GmbH's sole obligation shall be repair or replacement of
the 3M Deutschland GmbH product.
8.2 Limitation of Liability
Except where prohibited by law, 3M Deutschland GmbH will not be liable
for any loss or damage arising from this product, whether direct, indirect,
special, incidental or consequential, regardless of the theory asserted,
including warranty, contract, negligence or strict liability.
Information valid as of December 2011
Equipment for Disposal
Publicité
Table des Matières
