Mounting The Deflector; Mounting The Cutting Attachment - Stihl FSE 60 Notice D'emploi

Mounting the Deflector

2
1
Push the deflector (1) over the
N
clamp (2) as far as stop.
4
Fit the locknut (3) in the hex recess
N
on the deflector.
Make sure the holes line up.
N
Insert the M6x30 screw (4) and
N
tighten it down firmly.
FSE 60, FSE 71, FSE 81
Mounting the Cutting
Attachment
Placing Power Tool on the Ground
Switch off the power tool.
N
Lay your trimmer on its back with
N
the loop handle facing down and the
output shaft facing up.
3
Fitting Mowing Head without Screw
Mounting
Keep the instruction leaflet for the
mowing head in a safe place.
STIHL AutoCut C 5-2
8
2
9
Slip the mowing head (2) on to the
N
shaft – as AutoCut 5-2.
Turn the spool (9) clockwise until
N
the two arrow heads line up –
secure the spool in this position.
Insert the cap (8) in the spool, press
N
it down as far as stop and turn it
clockwise at the same time.
Turn the cap until you feel
N
resistance and then tighten it down
firmly by hand.
English
35