auna Oakland DAB Mode D'emploi page 41

Phono encoding
1. Set the function button to PHONO mode and then insert a memory
device (USB drive, SD or MMC card).
2. Put your record onto the turntable and get it ready for playback.
3. Press the record  REC button. It will take about 3-4 seconds to read
the memory device, then the USB or SD icon will be flashing on the LC
display.
4. Press the SKIP UP  or SKIP DOWN  button to select the desired
mode (USB or SD) for encoding, then press the record REC button again
to confirm.
(You can skip this step if only a USB drive or an SD/MMC card is
inserted.)
5. The system will start the encoding mode after a few seconds.
6. Lower the tone arm to start playback of the record. During encoding, the
USB or SD icon will be flashing on the display.
7. To finish encoding, press the stop button. The display will show "END"
and return to PHONO mode.
NOTE:
• The recording speed is 1:1. Recording will take as long as playing the
record.
• The recording format is preset at MP3 bit rate 128 kbps.
EN
41