Preparation For Use - auna Oakland DAB Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 53
EN
34

PREPARATION FOR USE

Unpacking and setup
Carefully remove the unit from the display carton and remove all
packing material from the unit.
Unwind the AC power cord and extend it to its full length.
Unwind the FM Antenna wire and extend it to its full length.
Place the unit on a stable, level surface, convenient to an AC outlet,
out of Direct sunlight, and away from sources of excess heat, dust,
moisture, humidity or strong magnetic fields.
Remove the opaque white plastic stylus cover from the phonograph
stylus by sliding it forward and down.
Discard the stylus cover
Remove the twist-tie that was used to secure the tone arm during
shipment.
Release the tone arm lock lever.
Connect the plug to your AC outlet.
Power source
This product is designed to operate on 230V 50Hz AC Mains only.
Attempting to operate this system from any other power source may cause
damage to the system, and such damage is not covered by your warranty.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

10033747100380021003800310038004

Table des Matières