BADU JET Perla Traduction Du Instruction D'utilisation Originale page 80

Faults
7 Faults
NOTICE
It is normal for a few drops of water to escape from the
mechanical seal from time to time. This is especially true during
the break-in period.
Depending on the water quality and number of operating hours,
the mechanical seal can begin to leak.
If water leaks constantly, have the mechanical seal replaced

by a qualified technician.
NOTICE
We recommend first informing the swimming pool contractor if
there are irregularities.
7.1 Overview
Problem: Unit cannot be switched on
Possible cause
Positional switch is not
snapped into place.
Problem: Pump is switched off by the built-in or external overload
switch.
Possible cause
Overload.
Media temperature too high.
Problem: Pump seizes.
Possible cause
Mechanical seal is stuck.
34 EN
Solution
 Check the cover position.
Solution
 Check pump. See point
7.1.1 on page 36.
 Wait for the motor winding
to cool down and the
motor protection to turn
back on.
 Reduce the media
temperature.
Solution
 Turn the motor shaft. See
point 6.1.2 on page 29.
 Clean pump and pump
parts.
10|2020