Troubleshooting - Panasonic WX-SE200DNP Mode D'emploi

Troubleshooting

Please check the common problems listed in this table before seeking professional
help.
If none of the tips provided here help, if you are dealing with a problem not listed here, or if
you are otherwise uncertain, contact your retailer for more information.
Problem
The product does not
turn ON
No audio is being
output
I cannot pair
microphones
The [STATUS]
indicator is flashing
green
38
PUQX1040ZAV1_WX-SE200DNP_OI_en-fr.indb
Cause/measure
● Is the power plug properly inserted into a power
outlet?
¨ Make sure that it is properly connected.
¨
● Is the LAN cable properly plugged in?
¨ Connect the cable to a receiver connector.
¨
● Is the output cable properly connected to the
output device?
¨ Connect the output cable to the output device.
¨
● Has the LAN cable become disconnected from the
Dante Network connector?
¨ Check whether the LAN cable is connected to
¨
the Dante Network connector.
● Is the [POWER] switch set to ON?
¨ Set the [POWER] switch to the ON position.
¨
Also set the [POWER] switch on the connected
receiver to the ON position.
● Is the volume adjustment knob set to a value
higher than [0]?
¨ Adjust the volume with the dedicated knob.
¨
● Is the LAN cable properly inserted?
¨ Connect the cable to a receiver connector.
¨
● Are there other microphones in use?
¨ Stop using the other microphone before pairing
¨
a new one.
● Are the batteries in the microphone exhausted?
¨ If they are, replace them (if they are
¨
nonrechargeable, alkaline batteries) or charge
them (if they are rechargeable batteries) before
pairing.
● Is the LAN cable properly inserted?
¨ Connect the cable to a receiver connector.
¨
38
Reference
page
16, 25,
26
15, 26
16, 25
16, 21,
22
14, 32
15, 32
15, 26
29, 31
Microphone
manual
15, 26
2022/04/27 13:19:25