Installation; Installation Precautions - Panasonic WX-SE200DNP Mode D'emploi

Table des Matières

Publicité

Installation

■ Installation precautions

Warning
When installing this product, follow all official ordinances on electrical equipment
technical standards.
This product is intended for indoor use
only
● It cannot be used outdoors.
Avoid exposing the product to direct
sunlight for extended periods of time,
and do not install it near air conditioners
or heaters. Failing to do so may lead to
damage to the shape and color of the
product, and may cause it to
malfunction. Also avoid exposure to
water droplets and bubbles.
Turn the product OFF to install it
● Remove the power cord from the power
socket before performing these
operations. Also turn OFF all mixers,
amplifiers, and other devices connected
to the extension receiver. Failing to do
so will result in a loud noise coming out
of the speakers and possibly damaging
the system.
PUQX1040ZAV1_WX-SE200DNP_OI_en-fr.indb
● Always ask a retailer to perform these operations.
● Before installation, set the power switch on the devices
you want to connect to OFF.
● Carefully read the "Precautions" section and follow all of
its instructions. Also refer to the manual of the devices
you are connecting.
● If this product is used in a residential environment, it
may cause wireless interference.
Installation place
● This product produces a large amount of
heat.
When installing product near a wall or
ceiling, make sure it has at least 10 cm
(3-15/16 inches) of clearance on all
sides (see figure below).
At least
10 cm
(3-15/16 inches)
● Place the product on a flat surface. Do
not place it upright with the rear surface
facing downward.
17
At least
Wall
10 cm
(3-15/16 inches)
At least 10 cm
(3-15/16 inches)
2022/04/27
17
13:19:21

Publicité

Chapitres

Table des Matières
loading

Table des Matières