Panasonic WX-SE200DNP Mode D'emploi page 29

3
Pair the microphone
Keep the [REG] button on a turned ON microphone pressed for at least two seconds to
start pairing it (the microphone [PWR] indicator will blink orange).
If pairing is completed successfully, the [PWR] indicator on the microphone will switch
to the normal status according to the remaining battery level (green, orange, or red),
and the [REG] indicator on the paired channel on the extension receiver lights green
for one second and goes off.
● If pairing could not be completed successfully, the [PWR] indicator on the
microphone blinks red. In that event, place the microphone as close as possible to
the antenna and try pairing it again. (Pairing may fail if the microphone is too far
away from the antenna or under bad connection conditions.)
WX-ST200P
Important
4
Place the battery cover back onto the microphone
Refer to the microphone manual for further details.
● The [REG] button is invalid if the channel to which microphone is paired and
if that microphone is in use. Turn the currently paired microphone power
OFF, then you can pair a different microphone to the channel that is already
in use.
● You cannot use pairing mode for multiple channels simultaneously.
● When a channel on the extension receiver is in pairing mode, all other
channels can still be used as normal.
● Paired microphones can be removed from the configuration/maintenance
PC installed the support software. Refer to the support software manual for
further details.
PUQX1040ZAV1_WX-SE200DNP_OI_en-fr.indb
WX-ST400P
Power indicator
Register
button
29
Power indicator
29
2022/04/27 13:19:24