Connecting Audio Output - Panasonic WX-SE200DNP Mode D'emploi

■ Connecting audio output

It is possible to mix the audio from the microphones of each channel and output this as an
analog audio signal to the amplifier (or mixer).
Connect an external device such as an amplifier to the [MIX OUT] connector on the
extension receiver.
1
Connect the wires to the included Euroblock connector
Connect the cables to the included Euroblock connector (6-pin) to connect to the [MIX
OUT] connector of this product.
Extension Receiver
Important
● Thoroughly connect the Euroblock connector to the extension receiver.
PUQX1040ZAV1_WX-SE200DNP_OI_en-fr.indb
MIX output connector
25
To AC120 V
60 Hz
electric outlet
To an amplifier or mixer
25
2022/04/27 13:19:23