Intended Use; Safety Information For The Installer - Sentiotec PRO D DMX Instructions Pour L'installation Et L'utilisation

Instructions for installation and use
1. About this instruction manual
Read these installation and operating instructions carefully and keep them within
reach when using the infrared control unit. This ensures that you can refer to
information on safety and operation at any time.
These installation and operating instructions can also be found in
the downloads section of our website: www.sentiotec.com/downloads.
2. Important information for your safety
The ProD DMX colour light control has been manufactured according
to the applicable safety regulations. However, hazards may arise
during use. Therefore adhere to the following safety information and
the specific warning notices in the individual chapters.

2.1. Intended use

The PROD DMX colour light control is exclusively used to control
the sentiotec LED RGBW spots/tubes by means of the sentiotec
DMX driver CC/CV
Any use exceeding this scope is considered improper use. Improper
use can result in serious injury or damage to the product.

2.2. Safety information for the installer

● It may only be fitted and installed when the power has been
disconnected.
● Installation may only be performed by a qualified electrician or
similarly qualified person.
● NEVER open the device.
● For your own safety, consult your supplier in the event of prob-
lems that are not explained in sufficient detail in the installation
instructions.
p. 2/8