Replacement Procedure - Sharp PW-E260 Mode D'emploi

All manuals and user guides at all-guides.com
When to replace the battery
Replace the battery immediately in the following cases:
• When is displayed.
• When the message 'Replace the battery' appears.
Note:
• If you do not follow the procedure describing the battery
replacement, the History list, as well as the Calculator's memory,
may be cleared or altered. Also, Currency converter and the Set-up
menu configurations may be reset.
• When is displayed, the backlight will not operate.

Replacement procedure

1. Switch off the power by pressing o.
2. Set the battery replacement switch located
on the bottom of the unit to the 'REPLACE
BATTERY' position.
3. Remove the battery cover.
4. Remove the used battery and insert the
one new battery. Make sure the battery
polarity is correctly oriented.
5. Replace the battery cover.
6. Set the battery replacement switch to the
'NORMAL OPERATION' position.
7. Open the unit and press o to turn the power on.
The LCD contrast screen appears.
• If the power cannot be switched on, try following steps 2 through
7 in the above procedure again. Should this fail, then follow the
reset procedure on the following page.
8. Follow the instructions on the screen to adjust the LCD contrast, as
well as to set the key sound on/off configuration (see steps 8
through 9 of the procedure on page 6.)
55