General Power Tool Safety Warnings; Work Area Safety; Electrical Safety - Parkside PMSA 12 B2 Traduction Des Instructions D'origine

Noise emission value:
Noise measurement value determined in accordance
with EN 62841 . The A-rated noise level of the
power tool is typically as follows:
Sound pressure level: L
Uncertainty K:
Sound power level:
Uncertainty K:
Wear hear muffs!
Vibration emission value:
Total vibration values (vector total of three directions)
determined in accordance with EN 62841:
Sawing a = <2 .5 m/s
2
Uncertainty K = 1 .5 m/s
NOTE
► The vibration emission values and the noise
emission values given in these instructions
have been measured in accordance with
a standardised test procedure and can be
used for comparison of the power tool with
another tool .
► The specified total vibration values and the
noise emission values can also be used to
make a provisional load estimate .
WARNING!
► Depending on the manner in which the power
tool is being used, and in particular the kind
of workpiece being worked, the vibration and
noise emission values can deviate from the
values given in these instructions during actual
use of the power tool .
► Try to keep the vibration loads as low as
possible . Measures to reduce the vibration
load are, e .g . wearing gloves and limiting the
working time . Wherein all states of operation
must be included (e .g . times when the power
tool is switched off and times where the power
tool is switched on but running without load) .
PMSA 12 B2
All manuals and user guides at all-guides.com
= 70 dB(A)
PA
K = 3 dB
PA
L = 81 dB(A)
WA
K = 3 dB
WA
2
General power tool
safety warnings
WARNING!
► Read all safety warnings, instructions,
illustrations and specifications provided
with this power tool. Failure to follow all
instructions listed below may result in electric
shock, fire and/or serious injury .
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers
to your mains-operated (corded) power tool or
battery-
operated (cordless) power tool .

1 . Work area safety

a) Keep work area clean and well lit.
Cluttered or dark areas invite accidents .
b) Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases or dust. Power tools
create sparks which may ignite the dust or
fumes .
c) Keep children and bystanders away while
operating a power tool. Distractions can
cause you to lose control .

2 . Electrical safety

a) Power tool plugs must match the outlet. Never
modify the plug in any way.
Do not use any adapter plugs with earthed
(grounded) power tools. Unmodified plugs
and matching outlets will reduce risk of electric
shock .
b) Avoid body contact with earthed or grounded
surfaces, such as pipes, radiators, ranges and
refrigerators. There is an increased risk of elec-
tric shock if your body is earthed or grounded .
c) Do not expose power tools to rain or wet
conditions. Water entering a power tool will
increase the risk of electric shock .
GB │ IE │ 17 ■