salmson SIE Serie Installation Et Mise En Service page 105

8.6.3 Navigation
±
1.0.0.0
±
2.0.0.0
4.0.0.0 4.1.0.0
5.0.0.0 4.2.0.0
4.4.0.0
Fig. 37: Navigation example
8.6.4 Changing selection/settings
±
5.6.3.0
12.3
Fig. 38: Setting with return to the "Selec-
tion/settings" menu element
±
2.0.0.0
12.3
Fig. 39: Setting with return to the status
page
Installation and operating instructions SIE, DIE, PBE
2 s
• Change to menu mode (see chapter 8.6.2 "Changing to menu mode"
on page 96).
Carry out general menu navigation as follows (for an example,
see Fig. 37):
During navigation, the menu number flashes.
• To select the menu element, turn the white button.
The menu number is incremented up or down. The symbol associated
with the menu element and the setpoint or actual value are shown, if
applicable.
• If the downward pointing arrow for "One level down" is shown, press
the white button to change to the next level down. The new menu
level is labelled on the display by the menu number, e.g., when chang-
4.4.1.0
ing from <4.4.0.0> to <4.4.1.0>.
The symbol for the menu element and/or the current value (setpoint,
actual value or selection) is shown.
4.4.3.0
• To return to the next higher menu level, select the "One level up"
menu element and press the white button.
The new menu level is labelled on the display by the menu number,
e.g., when changing from <4.4.1.0> to <4.4.0.0>.
NOTE:
If the white button is pressed for two seconds while a "One level up"
menu element is selected, the display jumps back to the status page.
To change a setpoint or a setting, generally proceed as follows (for an
example, see Fig. 38):
• Navigate to the desired "Selection/settings" menu element.
The current value or state of the setting and the associated symbol
5.6.3.0
are displayed.
300
• Press the white button. The symbol representing the setpoint or the
S
setting flashes.
• Turn the white button until the desired setpoint or setting is dis-
5.6.3.0
played. For an explanation of the settings represented by the sym-
10
bols, see the table in chapter 8.7 "Menu elements reference" on
S
page 99.
• Press the white button again.
The selected setpoint or setting is confirmed, and the value or symbol
stops flashing. The display is back in menu mode with the menu
number unchanged. The menu number flashes.
NOTE:
When values are changed under <1.0.0.0>, <2.0.0.0> and <3.0.0.0>,
<5.7.7.0> and <6.0.0.0>, the display jumps back to the status page
2.0.0.0
(Fig. 39).
2.0.0.0
2.0.0.0
English
97