Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
ADVERTENCIA
INSTALLATION INSTRUCTIONS
WARNING
ADVERTENCIA
WAR
NING
CAUTION
1. Clothes dryer installation must be performed by a
qualified installer.
2. Install the clothes dryer according to the manufacturer's
instructions and local codes.
3. To reduce the risk of severe injury or death, follow all
installation instructions.
4. Do not install a clothes dryer with flexible plastic venting materials.
If flexible metal (foil type) duct is installed, it must be of a specific
type identified by the appliance manufacturer as suitable for use
with clothes dryers. Flexible venting materials are known to collapse,
be easily crushed, and trap lint. These conditions will obstruct
clothes dryer airflow and increase the risk of fire.
SAVE THESE INSTRUCTIONS
Tools and materials required
•
Phillips-Head and flathead screwdrivers
•
Channel-lock adjustable pilers
•
1/2-inch open-end wrench
•
Carpenter's level
•
Measuring tape (12ft. min.)
•
Duct tape
•
Pipe thread sealer (Gas)
•
Rigid or flexible metal 4 inch (102cm) duct
•
Vent hood
Safety Warning:
1. Before starting installation, make sure that the gas shut off valve is in the
off position.
2. All old gas connectors and gas piping should be discarded.
ELECTRICAL REQUIREMENTS
C ircuit
Individual 15 Amp branch circuit fused with 15-Amp maximum time delay fuse
or circuit breakers.
P ower Supply
3 wire, 120 Volt, 1 Phase, 60Hz, AC
P ower Supply Cord
The dryer is equipped with a 120 Volt 3-wire power supply cord.
Note: This dryer is equipped with a three-prong grounding plug for your
protection against shock hazard and should be plugged into a properly
grounded three-prong receptacle. Do not under any circumstance cut or
remove grounding prong from plug.
5
All manuals and user guides at all-guides.com
ADVERTISSMENT
Risk of Fire:
ATTENTION
ATTENTION
ÓN
PRECAUCIÓN
Publicité
Chapitres
Table des Matières
