Installation Instructions; Tools Needed - Haier HLTD600AEW Manuel D'utilisation

INSTALLATION INSTRUCTIONS

Risk of Fire
Clothes dryer installation must be performed by a quali ed installer.
Install the clothes dryer according to the manufacturer's instructions and
local codes.
Do not install a clothes dryer with exible plastic venting materials. If
exible metal (foil type) duct is installed, it must be of a speci c type
identi ed by the appliance manufacturer as suitable for use with clothes
dryers. Flexible venting materials are known to collapse, be easily
crushed, and trap lint. These conditions will obstruct clothes dryer
air ow and increase the risk of re.
To reduce the risk of severe injury or death, follow all installation
instructions.
IMPORTANT: When discarding or storing your old clothes dryer, remove the
door.
Before you throw away your old appliance, remove the door or lid so
that children cannot hide or get trapped inside your old appliance.
Failure to follow these instructions can result in death or brain damage.
IMPORTANT: The dryer, when installed, must be electrically grounded in
accordance with local codes, or in the absence of local codes, with the Na-
tional Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code, CSA
C22.1.

TOOLS NEEDED

•
Phillips Screwdriver
•
Flat-Blade Screwdriver
•
Channel-Lock Adjustable Pliers
•
½" Open-End Wrench
•
Carpenter's Level
•
Measuring Tape (12 ft [3.7 m] min.)
WARNING
WARNING
Suffocation Hazard
•
Duct Tape
•
Cutting Knife
For gas installations only:
•
Pipe Wrench
•
2 Adjustable Wrenches
7