Installation Instructions; Tools And Materials Required; Safety Warning - Haier HDE5000AW Manuel D'utilisation

English

INSTALLATION INSTRUCTIONS

WARNING
CAUTION
1. Clothes dryer installation must be performed by a qualified installer.
CAUTION
2. Install the clothes dryer according to the manufacturer's instructions and local
codes.
3. Do not install a clothes dryer with flexible plastic venting materials. If flexible
metal (foil type) duct is installed, it must be of a specific type identified by the
appliance manufacturer as suitable for use with clothes dryers. Flexible
venting materials are known to collapse, be easily crushed and trap lint. These
conditions will ostruct clothes dryer airflow and increase the risk of fire.
4. To reduce the risk of severe injury or death, follow all installation instructions.

Tools and materials required

• Phillips-Head and flathead screwdrivers
• Channel-lock adjustable pilers
• 1/2-inch open-end wrench
• Carpenter's level
• Measuring tape (12ft. min.)
• Duct tape
• Pipe thread sealer (Gas)
• Rigid or flexible metal 4 inch (102cm) duct
• Vent hood

Safety Warning:

1. Before starting installation, make sure that the gas shut off valve is in the
off position.
2. All old gas connectors and gas piping should be discarded.
ELECTRICAL REQUIREMENTS (Electric Dryers)
Model Numbers:
C ircuit
Individual 30 Amp branch circuit fused with 30 Amp time-delay fuses or circuit
breakers.
5
ADVERTENCIA
ADVERTENCIA
WARNING
Risk of Fire:
PRECAUCIÓN
PRECAUCIÓN
(CHDE/HDE5000AW and CHDE/HDE5300AW)
ADVERTISSMENT
ATTENTION
PRECAUCIÓN