Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
Extending or retracting wheels
The wheels can be locked in different
positions.
The wheels can be retracted if they are
not required.
8
:
Loosen the rotary knob (8).
:
Engage rotary knob in required
position and tighten it down firmly.
18
All manuals and user guides at all-guides.com
Operating Instructions
During break-in period
A factory new machine should not be run
at high revs (full throttle off load) for the
first three tank fillings. This avoids
unnecessary high loads during the
break-in period. As all moving parts
have to bed in during the break-in
period, the frictional resistances in the
engine are greater during this period.
The engine develops its maximum
power after about 5 to 15 tank fillings.
During operation
After a long period of full-throttle
operation, allow engine to run for a while
at idle speed so that the heat in the
engine can be dissipated by flow of
cooling air. This protects engine-
mounted components (ignition,
carburetor) from thermal overload.
After finishing work
Storing for short period:
Wait for engine to cool down. To avoid
condensation, fill the fuel tank and keep
the unit in a dry place until you need it
again. Storing for a long period:
see chapter "Storing the Machine".
Replacing the Air Filter
2
1
Dirty air filters reduce engine power,
increase fuel consumption and make
starting more difficult.
If there is a noticeable loss of engine
power:
:
Set the choke lever to g
:
Loosen the screw (1) and remove
the filter cover (2).
:
Clean away loose dirt from inside
the cover and around the filter.
MM 55
Publicité
Chapitres
Table des Matières
