Extra Weight - Stihl MM 55 Notice D'emploi

English
If the engine does not start:
Choke lever
If you did not move the choke lever to e
quickly enough after the engine began to
fire, the combustion chamber has
flooded.
: Set the choke lever to e
: Move slide control, interlock lever
and throttle trigger to starting throttle
position.
: Start the engine by pulling the
starter rope firmly. 10 to 20 pulls
may be necessary.
If the engine still does not start:
10
: Move slide control to STOP.
: Pull off the spark plug boot (10).
16
All manuals and user guides at all-guides.com
: Unscrew and dry off the spark plug
: Open the throttle wide.
: Pull the starter rope several times to
clear the combustion chamber.
: Refit the spark plug.
: Connect the spark plug boot (press
it down firmly).
Move slide control to #
:
: Set the choke lever to e – even if
the engine is cold.
: Now start the engine.
Fuel tank run until dry
: After refuelling, press fuel pump
bulb at least five times – even if the
bulb is already filled with fuel.
: Set the choke lever according to
engine temperature.
: Now start the engine.

Extra Weight

An extra weight (special accessory) may
be retrofitted on the MultiEngine to
increase the weight on the MultiTool.
Only an original STIHL extra weight may
be used. Other weights may cause
damage to the unit and physical injury.
Mounting the extra weight
2
1
Unscrew weights on the side without
square end – as follows:
: Unscrew and remove the outer
weight.
: Unscrew inner weight and remove
from the bolt.
: Slide the extra weight (1) with bolt
through the bore (2) in the flange,
turning it until the square engages
the recess in the flange.
: Screw weight onto the bolt and
tighten it down firmly.
: Fit and tighten down the outer
weight firmly.
MM 55