Beurer HS 100 Mode D'emploi page 17

display
3
or decrease the temperature in 10°C increments� We recom-
mend the following temperature settings:
120 °C to 140 °C
160 °C to 180 °C
200 °C to 220 °C
7� The LED display
soon as the device is heated up, an acoustic signal sounds
and the LED display
now ready for use�
8� Part the hair into individual sections of approximately 3 to
4 cm�
9� Place the individual sections between the coated hot plates
close to the root�
1
10� Slowly move the device from the roots to the tips in a fluid
motion� Never hold the device in one place for more than two
seconds� This will achieve the best results without subjecting
your hair to excess stress or damage�
11� To shape the tips, turn the device outwards or inwards before
moving it over the tips�
12� Press the ON/OFF button
the device on a non-flammable surface�
13� After each use, pull the mains plug out of the socket� Leave
the device to completely cool down�
14� Store the device in a dry place out of the reach of children�
The fully cooled device can be stored and transported in the
heat-resistant storage box�
� You can use the temperature switch
for fine, brittle, coloured or bleached
hair
for normal hair
for thick and resistant hair
flashes during the heat-up phase� As
3
3
lights up continuously� The device is
to switch off the device� Place
4
17
to increase
6