Dräger FPS 7000 Notice D'utilisation page 22

All manuals and user guides at all-guides.com
Description
2.3 Intended use
The facepieces protect the face and eyes from aggressive media.
2.4 Limitation in the intended use
WARNING
!
Beards and sideburns in the sealing area of the full face mask
will cause leaks! Therefore the full face mask should not be
used by anyone with facial hair of this sort. Spectacle frames
in the sealing area also cause leaks. Use special mask
spectacles.
2.5 Approvals
The full face masks are approved as facepieces per EN 136:1998
CL.3+ and carry the CE mark. The mask/helmet combinations are also
approved according to DIN 58610. Both versions meet the
requirements specified in PPE Directive 89/686/EC. In addition, they
meet the flame engulfment requirements stipulated in EN 137.
Dräger FPS 7000 P and Dräger FPS 7000 RA facepieces correspond
to the NIOSH regulations from the USA.
Dräger FPS 7000 RA facepieces are approved in Australia and New
Zealand according to AS/NZS 1716:2012.
The facepieces are approved with the following SCBA series:
PAS Standard
PAS Lite
PSS 90
PSS 100
PSS 3000
PSS 5000
PSS 7000
22
The following mask/helmet combinations are approved:
Dräger FPS 7000 S-fix/HPS
Dräger FPS 7000 S-fix/F1
Dräger FPS 7000 S-fix/Supra
Dräger FPS 7000 Q-fix/HPS
NOTICE
i i
Full face masks must not be retrofitted to a mask/helmet com-
bination. Strictly follow the corresponding Instructions for Use
of the helmet.
The facepieces may only be used with approved SCBAs, fan filter
units, air line systems or respiratory filters.
The full face masks are tested in accordance with 94/9/EC for use in
potentially explosive atmospheres and can be used in the following
zones:
Full face masks with visor PC
I M1
II 1 G IIB T6 -30 °C ≤ Ta ≤ +60 °C
II 1D
Full face masks with visor PCas or PCaf
I M1
II 1G IIC T6 -30 °C ≤ Ta ≤ +60 °C
II 1D
Only use mask/helmet combinations with a water screen when in are-
as subject to explosion hazards.
(Certified by Dekra Exam) Dräger FPS 7000