Ebike Ready - SQlab LENKER 3OX Mode D'emploi

eBike Ready

SQlab products with the eBike Ready label are suitable for use on pedelecs in their respective ASTM F2043-13/ DIN EN 17406 category
from the point of view of function, ergonomics and operational stability (in accordance with the DIN EN ISO 4210 and DIN EN ISO 15194
standards).
The SQlab Label eBike Ready refers exclusively to the use on pedelecs with pedal assistance up to 25 km/h. The eBike Ready label can
be found on the packaging, the user manual and the product page of your SQlab product
Replacing the SQlab aluminum and SQlab carbon handlebars on Pedelec25
E­bikes and pedelecs with CE mark and pedal assistance up to 25 km/h are covered by the Machinery Directive, therefore components of
these bicycles may not be easily exchanged or modified. In order to clarify the situation, a guideline for replacing E­bike/Pedelec 25 parts
has been jointly released by the associations Zwerad­Industrie­Verband (ZIV) and Verbund Service und Fahrrad (VSF) in cooperation with
the Zedler­Institut and the Bundesinnungs­ band Fahrrad (BIV).
The guideline clearly regulates which bicycle dealers and workshops are allowed to replace parts on these vehicles and for which parts
they require approval from vehicle manufacturers or system suppliers. As such, it can be regarded as a recommended course of action.
Replacement of the SQlab aluminum and SQlab carbon handlebars bearing the eBike Ready label on Pedelec25 is possible based on the
recommendation „Guidelines for the re placement of components in CE­marked e­bikes/pedelecs with pedal assistance up to 25 km/h"
of the associations Zweirad­Indus trie­Verband (ZIV ) and Verbund Service und Fahrrad (VSF) in cooperation with the Zedler­Institut and
the Bundesinnungsverband Fahrrad (BIV), as far as the cable and/or line lengths do not need to be changed. The seat position should
be adjustable to consumer require ments without changing the original cable lengths. In addition, the load distribution on the wheel
changes significantly and potentially leads to critical steering characteristics.
On our website www.sq-lab.com/service/downloads/ in the service area under Downloads you will find a document called eBike Ready.
There you will find detailed information about the component exchange on Pedelec25, as well as the guide for the component exchange
made by the associations Zweirad­Industrie­Verband (ZIV), Verbund Service und Fahrrad (VSF), the Zedler Institute and the Bundesin­
nungsverband Fahrrad (BIV).
Caution: The SQlab handlebar 3OX Trial Fabio Wibmer is a handlebar especially designed for Trial, it is therefore NOT suitable for
on Pedelec25 and Pedelec45. All handlebars which are used in combination with the SQlab handlebar shim alloy 31.8 mm to 35.0 mm
are NOT approved for use on Pedelec25.
Replacing the SQlab aluminum and SQlab carbon handlebars on Pedelec45
Caution: SQlab handlebars and stems are currently NOT approved for fast pedelecs, the so­called S­pedelecs.