Troubleshooting And Fault Elimination; Fault Messages - Lenze EPM-H515 Instructions De Mise En Service

7

Troubleshooting and fault elimination

7.1

Fault messages

Call up the status messages of the operating unit to indicate the last occurred fault
message. (
Display Fault
No fault
NO ERROR
Faulty data
PR ERROR
exchange
Communication
COM BROK
interrupted
Communication Communication
ASI ASIC ko1 ko1
with system ith
ASIC ko2
bus (CAN) bus (CAN)
interrupted interrupted
ASIC ko3
ASIC ko4
RESET
SDOERR 6
SDOERR 5
SDOERR 3
EDBPM-H515 DE/EN/FR 2.0
Troubleshooting and fault elimination
70)
Cause
-
Connection between operating
unit and PC is faulty
Serial data cable between
operating unit and PC is
defective or not correctly
connected
Faulty wiring (e. g. polarity) of Faulty wiring (e g polarity) of y g ( g p
t th the system bus t b
Faulty parameter setting of Faulty parameter setting of
interface (baud rate, address, interface (baud rate, address,
identifier) de t e )
Fault messages
Remedy
-
Check connections for tight fit
Check cable for damages
Check correct connection and tight fit
of Sub-D plug
Exchange serial data cable
y) Check wiring of system bus (CAN) Check wiring of system bus (CAN) g
( ( 63) 63)
Check parameter setting ( HMI Check parameter setting ( HMI
Designer - Getting started). Designer - Getting started).
7
y ( )
85