Electrical Wiring - Burkert 1062 Manuel Utilisateur

8.2.

electrical wiring

dangEr
Risk of injury due to electrical discharge.
• Before starting work, switch off the power supply and secure it
to prevent restarting.
• Observe all applicable accident protection and safety regula-
tions for electrical equipment.
use a high quality electrical power supply (filtered and
regulated).
noTE
the tightness of the position feedback is not guaranteed
when the cover is removed.
• Prevent the projection of fluids into the position feedback.
the position feedback may be damaged if a metal com-
ponent comes into contact with the electronics.
• Prevent contact of the electronics with a metal component (a
screwdriver, for example).
→
Assemble the device as shown in Chapter
→
Carry out the electrical wiring in accordance with Chapter
to 8.2.6. for your version of the 1062.
→
Once the device has been wired, lock the cable so that it does
not impair the mobility of the duplication rod, by inserting it
28
All manuals and user guides at all-guides.com
7., before wiring it.
8.2.1.
English
Type 1062
Installationandwiring
into the notches provided for this purpose in the bottom of the
housing, as shown in Fig. 6 below:
Fig. 6 Final position of the cable