Burkert 1062 Manuel Utilisateur page 41

9. commissioninG
9.1. safety instructions
Warning
danger due to non-conforming commissioning.
Non conforming commissioning could lead to injuries and damage
the device and its surroundings.
• Before commissioning, make sure that the staff in charge have
read and fully understood the contents of the manual.
• In particular, observe the safety recommendations and intended
use.
• The device/installation must only be commissioned by suitably
trained staff.
• Protect the device against electromagnetic interference and
ultraviolet rays.
protect this device against electromagnetic interfe-
rence, ultraviolet rays and, when installed outdoors, the
effects of climatic conditions.
9.2. setting the cams
Activate the valve to check the correct detection of the open and/or
closed position.
If detection is incorrect, reposition each cam opposite its switch
according to the position of the valve as shown in the photos in Fig.
17.
34
All manuals and user guides at all-guides.com
English
Type 1062
Commissioning
Target of the valve
open switch
Target of the valve
closed switch
Fig. 17 Correct position of the cams in relation to the switches
→
Activate the valve
so that it opens
completely.
→
T h e t o p c a m
should be located
o p p o s i t e t h e
target of the valve
open switch.
→
Activate the valve
so that it closes
completely.
→
The bottom cam
should be located
opposite the target
of the valve closed
switch.