Cleaning, Storage, Checks, Troubleshooting - Christopeit Sport Cambridge II Notice De Montage Et D'utilisation

Training area in mm
(for home trainer and user)
Cleaning, Checks and Storage of the home bike:
1. Cleaning
Use only a less wet cloth for cleaning.
Caution: Never use benzene, thinner or other aggressive cleaning
agents for surface cleaning as this damage caused.
The device is only for private home use and for use suitable indoors.
Keep the unit clean and moisture from the device.
2. Storage
Remove the batteries from the computer while intending the unit
for more than 4 weeks not to use. Fold up the seat frame until it is
locked. Choose a dry storage in-house and spray some oil to the
thread of the handlebar bolt and on the thread of the quick release
for fold up function. Cover the bike to protect it from being discolor
by any sunlight and dirty through dust.
3. Checks
We recommend every 50 hours to review the screw connections for
tightness, which were prepared in the assembly. Every 100 operating
hours, you should spray some oil at the thread of the handlebar bolts
and to the thread of quick release for fold up function.
All manuals and user guides at all-guides.com
Free area in mm
(Training area and security area
(rotating 60cm))
Troubleshooting
If you cannot solve the problem with the following information,
please contact the authorized service center.
Problem
Computer
has no value
at Display if
you press any
key.
Computer is
not counting
data and do
not switch
on after start
cycling.
Computer is
not counting
data and do
not switch
on after start
cycling.
17
Possible Cause Solution
No Batteries insert Check the position of batte-
or batteries empty ries at battery compartment or
replace batteries.
Sensor impulse Check the plug connections at
missing base on computer and under the fold up
not well plugged constrcution.
connection
Sensor impulse Check the distance between
missing base on magnet and sensor. The magnet
not correct position which is positioned at seat slide
of sensor. should have only less than
< 5mm distance against the
sensor position.