Sync Modes; Sync Triggering; Bounce Flash - Hahnel MODUS 600RT MKII Mode D'emploi

Sync Modes

Press and hold the < Group B > button to select the High Speed
•
sync <
For 2nd Curtain Press and hold the < Group B > button again - <
•
> icon will switch on
Press and hold the < Group B > button again to go back to normal
•
sync
6

Sync Triggering

• The Sync Cord Jack is a Φ2.5mm plug. Insert a trigger plug here
and the flash will be fired synchronously with the camera shutter.
• To avoid overheating and deteriorating the flash head, do not fire the
modeling flash for more than 10 consecutive times. If you fire the modeling
flash 10 consecutive times, allow at least 10 minutes' break for the camera
flash.
• The modeling flash cannot be fired with the EOS 300 and Type-B
cameras.
Auto Focus Assist Beam
In poorly-lit or low-contrast shooting environments, the built-in auto
focus assist beam will automatically switch on to make it easier to
autofocus. The beam will light up only when autofocus is difficult and
will switch off as soon as the autofocus is set.
If you want to turn off the auto focus assist beam, set "AF" to "OFF" on
the C.Fn settings.
• If you find the auto focus assist beam does not light up, this is because
the camera has got a correct autofocus.

Bounce Flash

By pointing the flash head toward a wall or ceiling, the flash will bounce
off the surface before illuminating the subject. This can soften shadows
behind the subject for a more natural-looking shot. This is called
bounce flash.
To set the bounce direction, hold the flash head and turn it to the
required angle.
36
> icon will switch on
Other
Applications
Modus 600RT - English