Hahnel MODUS 600RT MKII Mode D'emploi page 26

Using Automatic Wireless Flash with
Multiple Slave Units
When stronger flash output or more convenient lighting operation
is needed, increase the number of slave speedlight's. To add slave
units, use the same steps as setting "automatic wireless flash with
a single slave unit" (Page 23). Any slave speeedlight can be set as
group (A/B/C).
When the number of slave units is increased or the master flash firing
is set to ON, automatic control is performed to fire all flashes at the
correct flash output to ensure that the total flash output results in the
standard exposure.
• If the slave unit's auto power off takes effect, press the master unit's test
flash button to turn on the slave unit. Note that the test flash cannot be
performed while the camera's metering timer, etc. is operating
• The slave units auto power off setting can be changed (C.Fn-Sv / APOT
page 46)
• In the C.Fn settings you can enable a beeper to sound when a Modus
600RT is recharged and ready to fire again
26
< > button until
MODE
<ETTL> is displayed
• Check that the slave unit is
set automatically to <ETTL>
by the master unit
5 Check Master/Slave units
are ready
• Check master speedlight,
ready indicator is lighting and
that the slave flash ready
indicators are blinking
6 Check the Master slave
speedlight operation
• Press the master unit's <
test button
• The slave speedlight will
flash. If it does not fire, check
the position or distance of
slave from master
• You are now ready to take a
photo with the wireless flash
lighting
>
Modus 600RT - English