Manual Preset; Tuning Into A Preset Station; Other Convenient Tuner Functions - JVC KD-S50 Manuel D'instructions

Manual preset

You can preset up to 6 stations in each band (FM1,
FM2, FM3 and AM) manually.
Ex: Storing an FM station of 88.3 MHz into the
preset number 1 of the FM1 band.
1
Select the band (FM1 – 3) you want to
store FM stations into (in this example,
FM1).
• Each time you press the button, the FM
band changes as follows:
F M
A M
2
Tune into a station of 88.3 MHz.
3
Press and hold the number button (in
this example, 1) for more than 2
seconds.
"P1" flashes for a few seconds.
4
Repeat the above procedure to store
other stations into other preset
numbers.
8
FM1 FM2
FM3
AM
¢ to tune
Press
stations of higher
frequencies.
Press 4
to tune
stations of lower
frequencies.
Notes:
• A previously preset station is erased when a new
station is stored in the same preset number.
• Preset stations are erased whent the power supply to
the memory circuit is interrupted (for example, during
battery replacement). If this occurs, preset the stations
again.

Tuning into a preset station

You can easily tune into a preset station.
Remember that you must store stations first. If you
have not stored them yet, see "Storing stations in
memory" on page 7 and 8.
1
Select the band (FM1 – 3, AM).
F M
A M
2
Select the number (1 – 6) for the preset
station you want.
7 8
Other convenient tuner
functions
RPT
SCAN
Scanning broadcast station
When you press RPT/SCAN while listening to the
radio, station scanning starts. Each time a broadcast
is tuned in, scanning stops for about 5 seconds
(tuned frequency number flashes on the display),
and you can check what program is now being
broadcasted.
If you want to listen to that program, press the same
button again to stop scanning.
FM1 FM2
FM3
AM
9 10 11 12