Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Function control Drive PLC
Make the connection between the PC and Drive PLC and the PC system bus module ONLY when the
equipment is switched off !
2
Step
€
Plug the copy-protection
dongle into LPT1 or LPTx
ó
Connect the PC system bus
module
ì
Switch on the supply voltage
for the Drive PLC.
ö
Switch on the PC
Set up the communication
parameters
Load the project example
Start program
Are there any faults during commissioning or regular operation ?
All manuals and user guides at all-guides.com
4
1
Note
›
"Drive PLC Developer Studio - Getting started", chapter 2.2
l
Do not forget the bus termination resistor (120 Ω)
l
Follow the instructions for the system bus module.
The permitted voltage is + 18 ... 30 V DC
Start the Drive PLC Developer Studio (DDS) software.
›
"Drive PLC Developer Studio - Getting started", Chapter
›
4.4.2
"Drive PLC Developer Studio - Getting started", Chapter 4.4
›
"Drive PLC Developer Studio - Getting started", Chapter
4.4.4
+18 ... 30 VDC / 0 V
X5
GND
HI
LOW
120Ω
0
3
?
82plc017
See
0
!
7
?
?
Publicité
Table des Matières
