Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
16 www.electrolux.com
7.1 Replacing the lamp
1
7.2 Closing the door
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer to
"Installation".
8. INSTALLATION
WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
8.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Cli-
Ambient temperature
mate
class
SN
+10°C to + 32°C
N
+16°C to + 32°C
ST
+16°C to + 38°C
T
+16°C to + 43°C
All manuals and user guides at all-guides.com
2
The appliance is equipped with a longlife
LED interior light.
1.
Disconnect the appliance.
2.
Push the movable part to unhook the
lamp cover (1).
3.
Remove the lamp cover (2).
4.
If needed replace the lamp with a light
of similar characteristic and power. It is
suggested to use Osram PARATHOM
SPECIAL T26 0.8 Watts.
5.
Install the lamp cover.
6.
Connect the appliance.
7.
Open the door. Make sure that the
lamp comes on.
3.
If necessary, replace the defective
door gaskets. Contact the Service
Center.
8.2 Electrical connection
Before plugging in, ensure that the volt-
age and frequency shown on the rating
plate correspond to your domestic power
supply.
The appliance must be earthed. The pow-
er supply cable plug is provided with a
contact for this purpose. If the domestic
power supply socket is not earthed, con-
nect the appliance to a separate earth in
compliance with current regulations, con-
sulting a qualified electrician.
The manufacturer declines all responsibili-
ty if the above safety precautions are not
observed.
This appliance complies with the E.E.C.
Directives.
Publicité
Chapitres
Table des Matières
