Publicité
Les langues disponibles
Les langues disponibles
14 www.electrolux.com
Problem
Water flows on the
ground.
The temperature in
the appliance is too
low.
The temperature in
the appliance is too
high.
The temperature in
the refrigerator is
too high.
The temperature in
the freezer is too
high.
Upper or lower
square is shown in
the temperature dis-
play.
DEMO appears on
the Display.
6.1 Replacing the lamp
The appliance is equipped with a longlife
LED light.
Only service is allowed to replace the
lighting device. Contact your Service Cen-
ter.
6.2 Closing the door
1.
Clean the door gaskets.
Possible cause
The melting water outlet
does not flow in the evap-
orative tray above the
compressor.
The temperature regulator
is not set correctly.
The temperature regulator
is not set correctly.
Many products are stored
at the same time.
There is no cold air circu-
lation in the appliance.
Products are too near to
each other.
An error has occurred in
measuring the tempera-
ture.
The appliance is in dem-
onstration mode (DEMO).
2.
3.
Solution
Attach the melting water
outlet to the evaporative
tray.
Set a higher temperature.
Set a lower temperature.
Store less products at the
same time.
Make sure that there is cold
air circulation in the appli-
ance.
Store products so that
there is cold air circulation.
Call your service represen-
tative (the cooling system
will continue to keep food
products cold, but temper-
ature adjustment will not be
possible).
Keep pressed approximate-
ly 10 sec. the Light button
since a long sound of buz-
zer is heard and the Display
shut off for a short while:
appliance start works regu-
larly.
If necessary, adjust the door. Refer to
"Installation".
If necessary, replace the defective
door gaskets. Contact the Service
Center.
Publicité
