Elmo Rietschle CLFH 220 Mode D'emploi page 8

A
Vacuum connection
B Exhaust air connection
E Cooling air entry
F Cooling air exit
Appendix:
Repair on Site: For all repairs on site an electrician must disconnect the
motor so that an accidental start of the unit cannot happen.
All engineers are recommended to consult the original manufacturer or one
of the subsidiaries, agents or service agents. The address of the closest
repair workshop can be obtained from the manufacturer on application.
After a repair or before re-installation, follow the instructions as shown under
the headings Installation and Initial Operation.
Lifting and Transport: To lift and transport the vacuum pump the eye bolts
on the pump and motor must be used. If an eye bolt is missing use suitably
rated strops.
The weight of the pumps are shown in the accompanying table.
Storage: The unit must be stored in dry ambient conditions with normal
humidity. If a pump needs to be stocked for a period longer than 3 months
we would recommend using an anti-corrosion oil rather than the normal
lubricant.
Disposal: The wearing parts (as listed in the spare parts lists) should be
disposed of with due regard to health and safety regulations.
Spare parts list: E 192 ➝ CLFH 220 (20)
Prematic AG, Märwilerstrasse 43, 9556 Affeltrangen www.prematic.ch
H, H
Oil filling point
1
I Oil check
K, K Oil drain point
1
M Oil type plate
N
Data plate
O Direction of rotation
CLFH # on request
50 Hz
Capacity m 3 /h
60 Hz
Ultimate vacuum mbar
50 Hz
Motor version 3 ~
60 Hz
50 Hz
Motor rating kW
60 Hz
50 Hz
Current drawn A
60 Hz
50 Hz
Speed min -1
60 Hz
50 Hz
Average noise level dB(A)
60 Hz
50 Hz
Noise level (max.) dB(A)
60 Hz
Weight kg
Oil capacity l
Tel. 071 918 60 60, Mail: v-g@prematic.ch
[mm]
220 (20)
220
264
0,5
230/400V ± 10%
220/380V
5,5
6,5
19,9 / 11,5
#
1450
1740
71
73
75
77
177
5,0
1.08 / PM7