Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8.6
NOTE
The time period for domestic hot water preparation should not exceed
20% of the heating load, as otherwise there is a danger that the building
heating load cannot be covered.
Setting range for "Domestic hot water" time period
Min: 5 minutes
Max: 1 hour 35 minutes
Flange heater (shut-off time):
The time period for the flange heater specifies the shut-off time
for the optional flange heater in the domestic hot water cylinder.
When the heat pump starts domestic hot water preparation, the
flange heater is shut off for the set time period. After the shut-off
time has elapsed, the flange heater switches on if a domestic hot
water demand is still present.
Recommended settings
The time periods should be coordinated so that the heating and
domestic hot water demand is in large part met using the heat
pump.In a low-energy house, the proportion for domestic hot
water preparation is around 20%.
Where the domestic hot water requirement is greater, the value
may also be significantly higher.
Example: Normal family home with domestic hot water prepara-
tion for 3 - 4 people:
Heating time period: 2 hours
Domestic hot water time period: 30 minutes
Flange heater time period: 1 hour
8.6 Setting
8.6.1 Settings menu
1)
Press
for 5 seconds to access the settings menu.
SETTING appears on the display.
2)
Press
/
to select a parameter.
3)
After selecting the parameter, press
corresponding settings.
4)
Press
/
to set the required temperature.
5)
Press
again to confirm your setting.
Repeat steps 2 to 5 to set other parameters.
EN-16
All manuals and user guides at all-guides.com
Operating
mode
HEAT
HEAT
HEAT
HEAT
HEAT
HEATER
TANK
8.6.2 Parallel translation of heating curve
Ensure that the operating LED is not lit before making this
setting.
1)
2)
3)
8.7 Setting the weekly timer
8.7.1 Timer display
to make the
Parameter*
Sets the external temperature at higher flow temperatures
(-15 to 15°C).
Sets the external temperature at lower flow temperatures
(-15 to 15°C).
Sets the flow temperature at a low external temperature
(25 to 55
°C).
Sets the flow temperature at a high
external temperature (25 to 55 ).
Sets the set temperature for switching off
heating operation (5 to 35 ).
Sets the external temperature for switching on the
supplementary heating, bivalence point (-15 to 20 °C).
Domestic water set temperature (40 to 75 °C).
Heating curve
70
3
55
40
25
10
-20
-15
-10
-5
0
1
External temperature
Press
for up to 5 seconds.
Press
/
to set the temperature offset (-5 to +5°C).
Press
again to confirm your setting.
4
5
10
15
20
2
Publicité
Table des Matières
