Festo SB-202 Notice Simplifiee page 12

SB-202 - 03/05
2
Configuration
PLEASE NOTE
The cover is connected to the internal PC boards via the
operating voltage cable. It cannot therefore be removed
completely.
CAUTION
The components of the valve terminal contain electrostati-
cally vulnerable elements. The components can be
damaged if the contact surfaces of plug connectors are
touched, or if the regulations for handling electrostatically
vulnerable components are not observed.
Please observe the following when configuring:
1. Switch off the operating voltage.
2. Open node (screws are liable to be lost).
3. Set baud rate.
4. Check switch settings (DIL 3, 4 and address selector).
5. Close node.
6. Cover the unused diagnostic interface with a protective
cap (IP65).
12
9709 NH