Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY
UNPACKING AND SETTING UP THE UNIT
1. Remove the two inserts from the top of the humidifier.
2. Open the water bottle covers. Remove the water bottles, lift off the chassis/power
pack and then remove the humidifier cabinet from the carton.
3. Remove the evaporative wick and all of the remaining packaging materials from
the cabinet. Check to see that you have all of the following items removed from
the boxes, accessory kit, and cabinet before discarding the packaging:
♦ Filler Hose
♦ Caster kit
♦ Bacterial treatment sample
♦ Evaporative Wick
CASTERS
4. With access to the bottom of the
cabinet, insert each caster stem
into a caster hole on each corner
of the humidifier bottom. The
casters should fit snugly and be
inserted until the stem shoulder
reaches the cabinet surface. Turn
the cabinet right side up.
EVAPORATIVE WICK
1.
When placing the wick back into the humidifier, the rod and float assembly must
also be reattached. Insert the top of the float rod through the hole on the
extended wick retainer (attached to the top of the wick frame)
♦ Water Bottle with cap
♦ Float, float rod and retainer
♦ Manual
NOTE:
To ensure bottle empties properly, use a bubble
level to verify the humidifier cabinet is placed on a
level surface.
4
Publicité
