Aircare H12 Serie Mode D'emploi page 10

TROUBLESHOOTING (cont')
Trouble
Odor
"CF" message does not
appear even when wick is
dirty or humidifier
performance is clearly
reduced.
Display blinks or fan moves
slightly when humidifier is
plugged in.
Alternating "F" and room
humidity displayed.
Alternating "CF" and room
humidity displayed.
Display flashes "20"
Display flashes "—"
Probable Cause
• Bacteria may be present.
• Loss of power or a
power failure has caused
the CF message to
prematurely reset.
• Normal
• Reservoir is empty.
• Float is not activating
switch on chassis
• Wick may be dirty.
• ROOM Humidity is lower
than 20%.
Unit cannot read below 20%.
• Unit initiating.
• Room humidity is over 95%.
10
Remedy
• Clean and disinfect cabinet following Care
and Maintenance instructions.
• Add EPA registered Bacteria Treatment
according to instructions on the bottle.
• It may be necessary to replace the wick if
odor persists.
• Replace wick.
• No action required.
• Fill humidifier with water.
• Reposition chassis so that float
and switch are aligned.
• Replace wick, if needed
• Unplug unit for 30 seconds and plug back in
to clear display.
• Set humidistat to 25-35% and increase
fan speed for several hours to
raise humidity. When Room reaches
25% the display will return to normal.
• Room humidity will display after
initiation is complete.
• Will remain until humidity drops
below 95%.