Ryobi RBL36JB Traduction Des Instructions Originales page 5

■
Do not operate the product near open
windows.
■
Use the full blower nozzle extension so that
the air stream can work close to the ground
and perform effectively.
■
Do not place blower on top of or near
loose debris. Debris can be sucked into the
intake vent, resulting in possible damage
to the product.
TRANSPORTATION AND STORAGE
■
Stop the product, remove the battery, and
allow it to cool before storing or transporting.
■
Clean all foreign materials from the product.
Store the product in a cool, dry, and well-
ventilated place that is inaccessible to
children. Keep away from corrosive agents,
such as garden chemicals and de-icing
salts. Do not store outdoors.
■
For transportation in vehicles, secure the
product against movement or falling to
prevent injury to persons or damage to the
product.
TRANSPORTING LITHIUM BATTERIES
Transport the battery in accordance with local
and national provisions and regulations.
Follow all special requirements on packaging
and labelling when transporting batteries by a
third party. Ensure that no batteries can come
in contact with other batteries or conductive
materials while in transport by protecting
exposed connectors with insulating, non-
conductive caps or tape. Do not transport
batteries that are cracked or leaking. Check
with the forwarding company for further
advice.
MAINTENANCE
WARNING
Use only original manufacturer's replacement
parts, accessories, and attachments. Failure
to do so can cause possible injury and poor
performance, and may void your warranty.
WARNING
Servicing requires
knowledge and should be performed only by
a qualifi ed service technician. For service,
bring the product to an authorised service
centre. When servicing, use only identical
replacement parts.
■
Do not make adjustments and repairs not
described in this manual. For other repairs,
contact an authorised service agent.
■
After each use, clean the product with a
soft, dry cloth.
■
Check all nuts, bolts, and screws at
frequent intervals for proper tightness to
ensure that the product is in safe working
condition. Any part that is damaged should
be properly repaired or replaced by an
authorised service centre.
■
Bring the product to an authorised service
centre to replace damaged or unreadable
labels.
RESIDUAL RISKS
Even when the product is used as prescribed,
it is still impossible to completely eliminate
certain residual risk factors. The following
hazards may arise in use and the operator
should pay special attention to avoid the
following:
■
Injury caused by vibration. Always use the
right tool for the job and use designated
handles.
■
Hearing injury caused by exposure to noise.
Wear ear protection and limit exposure.
■
Injury from flying objects from the blow tube
airflow. Wear eye protection at all times.
RISK REDUCTION
It has been reported that vibrations from
handheld tools may contribute to a condition
called Raynaud's Syndrome. Symptoms may
include tingling, numbness, and blanching of
the fi ngers, usually apparent upon exposure to
cold. Hereditary factors, exposure to cold and
dampness, diet, smoking, and work practices
are all thought to contribute to the development
of the these symptoms. There are measures
that can be taken by the operator to possibly
reduce the effects of vibration:
extreme care and
English | 3
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR