Acoustic Signals; Technical Specifications - Faro DKL L2-ECO Notice D'utilisation

ACOuSTIC SIgNALS

OTP*
MAX
MIN
1 BEEP
1 BEEP
OpL**
* OTP: Over-temperature protection
** OpL: LED charger unplugged
TROuBLESHOOTINg
The light does not switch on
The light intensity is considerably
reduced
Patches have appeared on the
reflectors (dishes)

TECHNICAL SPECIFICATIONS

Power voltage (without transformer)
Power voltage (with transformer)
Absorbed power
Fuses (version with transformer)
Protection against electrical hazards
OPTICAL SPECIFICATIONS IN COMPLIANCE WITH ISO 9680
Luminous spot dimensions
Lux
Colour temperature
CRI (color rendering index)
* Typical value
20
= Beep 30 seconds
= 1 beep - 2 beep with proximity
= 1 beep
= On the commands
= At start-up
=
Beep 30 seconds
Label compliant with EN 60825-1:94+A1:02+A2:01
– Check that the power supply is on.
– Check the state of the fuses.
– If none of these causes is verified, consult technical
assistance.
– Clean the parabolas.
If the light intensity does not return to initial values,
consult technical assistance.
– Clean t he s urfaces w ith t he s pecific p roduct " Faro R eflex".
– Clean the surfaces with isopropyl alcohol.
– An unsuitable product for cleaning or disinfection has
been used that has damaged the surfaces.
– Contact customer care FARO.
: 17÷24V ac ± 10%
22÷35V dc
: 230 V 50/60 Hz
: 26 W
: 2 x T250mA 250V
: Device class II
: 180 mm x 90 mm
: 3000*-50000* lux @700mm
: 5000 K
: >95*
-
50/60 Hz