Package Contents; Parts And Controls; Using The Power Bank - Beurer HK 57 Mode D'emploi

Enveloppe thermique to go pour les épaules
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

• Batteries must be charged correctly prior to use. The instructions from the manufacturer and
the specifications in these instructions for use regarding correct charging must be observed at
all times.
• For pluggable equipment, the socket-outlet shall be installed near the equipment and shall be
easily accessible.
• Never expose the power bank to extreme heat. This applies in particular to storage in a car.
Extreme temperatures can occur inside the vehicle and in the glove compartment when the
vehicle is parked for a long period of time. Therefore, remove the power bank from the vehicle.
• If you have any questions about using this device, contact Customer Service.
CAUTION
This heating wrap is equipped with a Safety Shut-off Sensor that prevents the heat-
ing wrap from overheating. If the Safety Shut-off Sensor is triggered the Power Button on the
heating wrap and the white LED on the power bank remain illuminated. After cooling down, the
heating wrap switches on automatically.

2. Package Contents

1 x Shoulder Heating Wrap To Go HK57
1 x Power Bank Type WE-213
1 x Charging Cable
1 x Storage Bag
1 x Instruction Manual

3. Parts and Controls

1. Power Bank Type WE-213
2. Heating Wrap
3. Power Button
4. Power Cable
5. Charging Cable
6. Storage Bag

4. Using the Power Bank

Charge the Power Bank before initial use and if the device has not been used for a long period.
To charge:
1. Insert the provided Charging Cable into the connection socket of the Power Bank.
2. Connect the other end of the Charging Cable to a USB charger via the USB port (USB charger not included)
with at least a 1-Amp output. The Battery Level LED on the Power Bank will flash white while charging.
The charging/decharging levels are as follows:
1 x flash: 0 % - 25 %
2 x flash: 26 % - 50 %
3 x flash: 51 % - 75 %
4 x flash: 76 % - 99 %
Steady on 100 %
3. The Power Bank is fully charged when the Battery Level LED stop flashing and displays steadily (about
4.5 hours for a completely discharged Power Bank).
4. Disconnect the Charging Cable; the LED will shut off. Charge the Power Bank at least once per year to
maintain its capacity.
1
4
5
4
2
3
6

Publicité

Table des Matières
loading

Table des Matières