Automatismos Pujol Mini Marathon Instructions De Montage Et De Réglage page 35

mini marathon
STRENGTH REGULATION
Turning the strength potentiometer clockwise, allows the door to exert more strength before it stops and reverses,
when overexertion is detected by the hall sensor. When it is turned counter clockwise, the sensor becomes more
sensitive in the event of an obstacle.
Less strength
More strength
Menos Mas
SHOCK ABSORPTION REGULATION
When the potentiometer is turned clockwise the door absorbs more shock during the smooth stop (slower speed,
less strength, greater sensibility to obstacles). When the potentiometer is turned counter clockwise the door
absorbs less shock during the smooth stop (greater speed, more strength, less sensibility to obstacles).
Less
More
Menos Mas
CHECKING THE MANEUVER DIRECTION
When the door is electrically connected and the alternative pushbutton or open button is activated, the first
maneuver of the door is to open. Position the door in the middle of its stroke, connect power to the system,
activate the alternative pushbutton and the door should open. If not, change the position of microswitch nº 3.
Adjust the strength to the desired level (this can be done while the door is moving).
PROGRAMMING THE DOOR'S STROKE AND AUTOMATIC CLOSE
For the door to come to a gentle stop before the end of its stroke, it is necessary to program its stroke. On this
maneuver, the automatic close time and the smooth stop will also be programmed (see Smooth stop
programming). To program the stroke, the door must be completely closed. Press the programming pushbutton
PROG for 1.5 seconds. The red Led will blink, showing that the equipment is ready to be programmed. The stroke
can now be programmed. The programming process closes automatically upon completing a door cycle.
Stroke programming process
1) With the door at the closed position, activate the programming mode as explained above, the red LED will flash
intermittently.
2) Start the opening maneuver by pressing the alternative pushbutton "P.ALT" or the remote control.
The opening maneuver terminates on detection of a bumper and the opening stroke will be memorised.
3) With the door open, the automatic close time will be recorded until the closing maneuver starts.
4) Start the closing maneuver by pressing the alternative pushbutton "P.ALT" or the remote control.
The closing maneuver terminates on detection of a bumper and the closing stroke will be memorised.
5) The programming will be automatically disabled when a complete door cycle is over.
The maximum recording time is 2 minutes, after which the maneuver will end and the limit will be recorded.
If the programming is enabled but no maneuver is performed, after 1 minute the programming will be disabled.
During programming the motor operates at a lower speed.
SMOOTH STOP PROGRAMMING
If switch no. 8 is set to ON for a variable smooth stop at the end of the maneuver, then during programming the
alternative pushbutton should be activated in the spot where we want the smooth stop to commence. This is
applicable to both the opening and closing maneuvers. For example, if we are programming the opening, then
with the door closed we activate the alternative pushbutton, making the door open. When it gets to the spot
where we think it should slow down (Smooth Stop) we activate the alternative pushbutton, which reduces the
door's speed until it gets to the end of stroke bumper. With these steps, the maneuver times and smooth stop
times for the opening maneuver, will be programmed.
automatismos pujol - 35 - english