Assembling The Sausage Stuff Er Attachment - SilverCrest SFW 350 C1 Mode D'emploi

GB
Assembling the sausage stuff er attachment
38
5) Place your selected cutting disc 9 into the meat grinder casing 5 so that
the fi xings on the cutting disc 9 are located in the openings in the meat
grinder casing 5.
6) After everything has been correctly assembled, screw the ring clamp 0
back on hand-tight.
7) The ready-assembled meat grinder casing 5 is connected by a bayonet
connector to the motor block 4:
Insert the meat grinder casing 5 into the motor block 4 such that the
–
arrow on the meat grinder casing 5 lies against the symbol
motor unit 4. The locking button presses itself in (Fig. B).
Lightly press the meat grinder casing 5 in and at the same time turn
–
the feeding shaft on the meat grinder casing 5 into the middle position
(Fig. B) so that the arrow on the feeding shaft points to the symbol
When the meat grinder casing 5 engages, the locking button springs out.
Finally, place the feeding tray 3 on top of the feeding funnel.
–
– To dismantle it, press the locking button and turn the feeding funnel to
the right (Fig. B)
Unfold the fold-out side - there you will fi nd the step-by-step illustrations for as-
sembling the appliance.
1) Remove the meat grinder casing 5 as described under "Assembling the
meat grinder".
2) Disassemble any attachments that might be fi tted and clean the meat grinder
casing 5.
NOTICE
For the sausage stuff er attachment q, the cross blade 8 with the spring 7
►
is not required! If need be, remove them both from the meat grinder casing 5.
3) Coat all metal parts with cooking oil.
4) Insert the sausage disc w so that the fi xings on the sausage disc w are
located in the openings in the meat grinder casing 5.
5) Then place the sausage stuff er attachment q before the sausage disc w.
6) Screw the ring clamp 0 on hand-tight.
7) Assemble the meat grinder casing 5 as described under "Assembling the
meat grinder".
. You can now pull the meat grinder casing 5 out.
on the
.
SFW 350 C1