Changing Configuration Parameters - Videotec KEYPLUS Manuel D'instructions

Changing configuration parameters

To change parameters follow the next steps:
• get into configuration
• choose a menu; get into it
• choose the wished option value among the available ones
• exit from menu
• repeat the previous phase for each parameter
• exit from programming mode.
Example: to change enabled outputs, selectable from the keyboard.
To begin programming mode
Switch on the keyboard. Press
necessary, insert the setup password.
To choose a menu and to change parameters
Menu is shown on two rows:
• menu title (in this case KEYBOARD MENU)
• list of available submenus
U D
Pressing and
Recall the submenu Enabled par. by pressing
parameters you want to set (inputs, outputs, keys, etc.).
To carry on with the example, by
E
by .
To configure enabled outputs, choose each of them and define it selectable or not
selectable:
• choose the output number by pressing
E
• press
to enable / disable it
Parameters are automatically saved exiting from the menu
C
to go back to the previous menu.
Return to main menu by pressing
To exit programming mode
At the end of programming the keyboard confirms the saving of the set
parameters and restores the normal functioning.
You can exit from main menu in two different ways:
C
• by pressing
• by choosing Exit Setup, and confirming by
P
for 5 seconds, until the leds begin to flash. If
select the menu (Enabled par.)
D
choose the submenu Outputs and recall it
U
and
C
.
E
, choose which group of
D
E
.
Page 11
Display
CONFIGURATION
--- KEYBOARD ---
Display
KEYBOARD MENU:
1.Language
KEYBOARD MENU:
5.Enabled par.
ENABLED PAR. 5.
Inputs
ENABLED PAR. 5.
Outputs
ENABLED OUTS 5.2
Output 1: YES ¤£
ENABLED OUTS 5.2
Output 3: NO ¤¢
ENABLED PAR. 5.
Outputs
KEYBOARD MENU
5.Enabled par.
Display
KEYBOARD MENU
Exit setup
KEYPLUS9702