wallas 85 Dt Mode D'emploi page 69

FUEL
200 mm
400 mm
500 mm
Safety distances
Transom
Transom
D10121A
85 Dt / Nordic Dt
Installation
Exhaust gas connections
General instructions for exhaust gas connections
Location
Air must always fl ow freely past the lead-through. Install the lead-through on a fl at
surface. Avoid corners or recessions where wind pressure can disturb the function-
ing of the device.
The minimum distance of the lead-through from the fuel tank's fi ller hole is 400 mm
(16").
The minimum distance of the side lead-through from the surface of the water is
500 mm (20"). Especially in sail boats it should be noted that the lead-through must
never be submerged.
It is recommended to place the lead-through in the side as far back as possible or
directly in the transom.
Good places for Wallas
=
through hull fi ttings
Min 300 mm (12")
Min 500 mm (20")
Recommended locations for Wallas through hull fi ttings in motorboats
Min 300 mm (12")
Recommended locations for Wallas through hull fi ttings in sailing boats
Especially in sail boats it should be noted that the lead-through must
never be submerged.
1 / 1 /
4 4
Min 500 mm (20")
- 69 -
en en
Possible places for Wallas
=
through hull fi ttings
WIDEST POINT OF BEAM
1 / 1 /
4 4
WIDEST POINT OF BEAM
490539