wallas 85 Dt Mode D'emploi page 64

D10031
85 Dt / Nordic Dt
Installation
Installation instructions for Tank connection 30011 (accessory)
• You will need to make a ø 25 mm (1") hole in the upper surface of the fuel
tank. Choose the location of the hole so that when the boat tilts the end of the
intake pipe will stay in the fuel even if the tank is not full. If the end of the intake
pipe does not reach the fuel, the device will quickly choke on the air in the fuel
system.
• Cut the fuel intake pipe (ø 6 mm) to the appropriate length. The end of the pipe
must not touch the bottom of the tank in order to keep water and sediment from
the system. It is recommended to cut the pipe short enough to leave the engine
intake pipe at a lower level. This way the device cannot empty the tank.
• Install the pipe straight end fi rst and angle the two "ears" below the threaded
barrel inside the hole and then align the threaded barrel vertically so the ears
are hooked on the underside of the tank top. Carefully slip the rubber washer
over the bent pipe end and over the threaded barrel, followed by the metal
washer and the nut. Thread the nut to the threaded barrel and tighten, sealing
the fi tting to the top surface of the tank.
Intake pipe ø 6/3 mm
Tightening nut
Rubber seal press head
Rubber seal
Fuel tank
If the device uses the main tank of the boat, note that the device can-
not take the fuel from the same fuel output line as the engine of the
boat.
ø 25 mm
(ø 1")
- 64 -
en en
490539