wallas 85 Dt Mode D'emploi page 58

D10291
85 Dt / Nordic Dt
Installation
Fastening the device
Place the stove in the installation cut-out and attach the iron fasteners (1) with the
screws M6x12 (2) to the rivet nuts at the ends. After this, install the cover plug (3)
on the end of the screw and tighten the iron fasteners against the table with the
screw M6x30 (4). Remember the locking nuts M6 (5).
Attach the iron fasteners to the stove (1) with screws (2).
3
Thin table
The iron fasteners can be installed in two ways depending on the thickness of the table board.
Tighten the screw (4) fi rmly against the table board and then tighten the locking nut (5).
Always use original Wallas accessories and parts with Wallas equip-
ment.
1
Thick table
5
4
Push the cover plug (3) on the screw.
- 58 -
en en
1
2
490539