wallas 85 Dt Mode D'emploi page 59

Use pliers to hold
the pump inlet elbow
steady, while you
tighten the 12 mm fuel
line nut!
D10291
85 Dt / Nordic Dt
Connections of the device
Things to note about the connections
In installation, to make the mounting and demounting for service easier, it is recom-
mended to leave some extra length of loose cables and fuel line by creating a coil.
If the installation location is cramped, it is recommend to connect the cabels and
the fuel line to the device before mounting the unit to bracket. This will help the
installation of device.
Power cable
Fuel hose
In a metal-hulled boat, you must ensure that the device, the fl ue gas
lead-through, the fuel connection, the control panel, and all other
parts are insulated from the boat's hull. This must be done to:
• prevent electrochemical corrosion
• prevent voltage from being transmitted from the hull to the device
or vice versa during electrical faults.
Installation
Control panel
- 59 -
en en
Heat blower lid
(accessory)
Exhaust
Out
Solenoid valve
(accessory)
490539