Dräger X-am 3500 Mode D'emploi page 33

The rating plate on the gas detector must not be
concealed.
3.6 Sensor slots X-am 3500
Term
Sensor slot
HPP 1 (High Power Port)
HPP 2 (High Power Port)
EC 1-3 (Electro Chemical) EC sensors
4 Operation
4.1 Operating concept
Navigation is done with the 3 multifeature buttons and
the dynamic navigation bar (see Graphic E on the fold-
out page). The navigation bar changes dynamically
depending on the available interactions.
4.2 Symbol explanations
4.2.1 feature buttons
Symbol Explanation
Confirm action/dialog / return to menu
Confirm all
Scroll up / through display
Scroll down / through display
Cancel action
Display quick menu
Display measuring channels individu-
ally
Display all measuring channels
Increase value
Decrease value
Repeat feature
Display menu
X-am
Configuration
not assigned
CatEx sensor
®
3500
4.2.2 Displays
Symbol Explanation
Horn and vibration for gas alarm deac-
tivated
4.2.3 Application
Symbol Explanation
Messen
Fresh air adjustment
Bump test or calibration
4.2.4 Device status
Symbol Explanation
Overview of the bump test intervals
activated (additional information for
the D-Light feature).
There are no gas alarms or errors.
Monitoring of the calibration intervals
activated, D-Light function deacti-
vated (additional information for the D-
Light function).
There are no gas alarms or errors.
Alarm message
Warning message
The gas detector can be operated nor-
mally. If the warning message is still
displayed after operation, the gas
detector requires maintenance. Menu
Messages displays details.
Fault message
The gas detector or measuring chan-
nel is not ready to measure and
requires maintenance. Menu Mes-
sages displays details.
Information message
Menu Messages displays details.
STEL alarm message
TWA alarm message
4.2.5 Connection
Symbol Explanation
Maintenance mode (access to the
device via PC or X-dock)
Operation en