Publicité
Les langues disponibles
Les langues disponibles
Using the Radio Data System (RDS) (continued)
„ To recall stations in memory
To specify programmed types and select stations (PTY search):
You can search a station by specifying the programme type (news, sports, traffic pro-
gramme, etc. ... see page 20) from the stations in memory.
1
Press the TUNER (BAND) button to select the FM.
2
Press the PTY.TI SEARCH button.
"SELECT" and "PTY TI" will appear alternately for about 6 seconds.
3
Within 6 seconds, press the PRESET (
programme type.
Each time the button is pressed, the programme type will appear. If the button is
held down for more than 0.5 seconds, the programme type will appear continu-
ously.
4
Whilst the selected programme type is flashing (within 4 seconds),
press the PTY.TI SEARCH button again.
After the selected programme type has been lit for 2 seconds, "SEARCH" will ap-
pear, and the search operation will start.
E-22
ENGLISH
Notes:
z If the display has stopped flashing, start again from step 2. If the unit finds out a
z If you want to listen to the same programme type of another station, press the
z If no station can be found, "NOT FOUND" will appear for 4 seconds.
If you select the traffic programme:
If you select the traffic programme (TP) in step 4, "TP" will appear. (This does not
mean that you can listen to the traffic information at that time.)
When a traffic information is broadcast, "TA" will appear.
To specify station names and select stations manually:
You can select a station by specifying the name (BBC R1, BBC R2, etc.) from the sta-
tions stored in memory.
Before starting this operation, you must store one or more station names in memory.
1 Press the TUNER (BAND) button to select the FM band.
2
or
) button to select the
3 The station name will be displayed for 6 seconds. Then the display will change as
desired programme type, corresponding channel number will flash for about 4 sec-
onds, and then the station name will flash for 7 seconds, and then will remain lit.
PTY.TI SEARCH button whilst the channel number or station name is flashing. The
unit will look for the next station.
Press the PRESET (
or
) button to select a desired station.
follows.
Publicité
